2.5" SATA III
2.5‑inch SATA solid-state drive for systems with a standard 2.5‑inch drive bay. Available configurations include 128 GB–4 TB on SATA III (SATA Rev. 3.2).
Technical Summary
Key Features
- Global wear leveling
- Bad block management
- TRIM and S.M.A.R.T. support
- Secure erase and firmware update
- Software / hardware write protection
- RoHS compliant
Ordering Information
Industrial Ordering Part Numbers
| Ordering P/N | Capacity | Interface | Datasheet |
|---|---|---|---|
| SMC128GSSD110 | 128 GB | SATA III (SATA Rev. 3.2) | On Request → |
| SMC512GSSD110 | 512 GB | SATA III (SATA Rev. 3.2) | On Request → |
| SMC002TSSD110 | 2 TB | SATA III (SATA Rev. 3.2) | On Request → |
Part numbers for capacities not listed are available on request.
Performance & Endurance
The speeds shown above are the highest sequential read and write values in this product family. Performance varies by capacity; see the table below for the datasheet values for each capacity.
| Capacity | Sequential read | Sequential write | TBW |
|---|---|---|---|
| 128 GB | 520 MB/s | 470 MB/s | 75 TB |
| 256 GB | 520 MB/s | 480 MB/s | 150 TB |
| 512 GB | 520 MB/s | 500 MB/s | 300 TB |
| 1 TB | 540 MB/s | 520 MB/s | 600 TB |
| 2 TB | 550 MB/s | 520 MB/s | 1200 TB |
| 4 TB | 550 MB/s | 520 MB/s | 2400 TB |
Mechanical Specifications
Environmental Specifications
Compatibility & Qualification
Drive selection is determined by the available bay or socket, the host interface and the board layout. Compatibility verification is performed against the applicable target configuration according to project requirements.
Industrial Program Controls
Production Verification
Production-level verification
- Incoming, in-process, final and outgoing quality control
- Firmware version verification before shipment
- Drive functional verification before shipment
Project-level qualification
- Target-platform compatibility verification
- Stability verification under the defined operating conditions
- Application-specific qualification where the program requires it
Production-level verification is part of the manufacturing flow. Project-level qualification is scoped per program.
Technical Documentation
Product Configuration Review
Provide the target platform, the required capacity, the host interface, operating conditions and expected program lifecycle. SIMORCHIP engineering will review the applicable drive configuration and qualification requirements.